Log in Start free

Search

Pricing

Forum

Contact

Engine: Motor Plants and Auxiliary Boilers

Question 860 of 947

What is the maximum allowable clearance permitted between the bearing, shown in the illustration and the shaft along its vertical axis? Illustration MO-0121

USCG illustration MO-0121 for Engine Motor Plants and Auxiliary Boilers question 860 — Illustration MO-0121

0 ✓ | 0 ✕ 10 free left today

Tip: press A-D to answer

More Motor Plants and Auxiliary Boilers questions

#852 Which of the following devices will increase the power output of a diesel engine without increasing its frictional load?
#858 Which of the couplings listed is normally not repairable, and is usually replaced if completely damaged?
#861 What is the normal bearing clearance permitted at the horizontal axis of the shaft for the bearing shown in the illustra...
#862 After following the prescribed procedures to measure the thrust bearing clearance shown in the illustration, the distanc...
#863 When an additional load is applied to a diesel engine which is using an inadequately inflated air bladder clutch unit, y...

Mariner discussion

Comments from mariners who studied this question.

hu hubba512 · Dec 14, 2015

This question is asking for dimension gf. The answer does not match what the question is asking.