MODU – Chief Engineer Practice Test

1. 1. Which of the following statements is correct concerning the connecting rod and piston assembly shown in the illustration? Illustration MO-0011
2. 2. Ring groove inserts are occasionally used on aluminum alloy pistons to __________.
3. 3. The lower water seal on a diesel engine wet cylinder liner must allow for liner axial movement. This seal is most commonly a __________.
4. 4. Item #16 of the piston shown in the illustration is a/an __________.
5. 5. Trunk type diesel engine pistons are effectively cooled when heat is __________.

Showing the first 5 of 70. Start at question 1 and use Next to work through the module →

1. 1. The safe and efficient use of the facepiece of a self-contained breathing apparatus is directly influenced by __________.
2. 2. Which of the following statements is TRUE concerning life jackets?
3. 3. A rigid lifesaving device designed for a group of survivors to hold on to while in the water is defined as a _______.
4. 4. An immersion suit should be equipped with a/an __________.
5. 5. With the sprinkler system and air system on, and all hatches shut, the survival craft will be protected from __________.

Showing the first 5 of 70. Start at question 1 and use Next to work through the module →

1. 1. A hydraulic flow control circuit is shown in the illustration and is known as a __________.
2. 2. The line labeled "E", as shown in the illustration, would be identified as the ______.
3. 3. As shown in the illustration, a section of standard weight, seamless steel pipe, has an external diameter of 4.0 inches. When the pipe, is bent into a 90-degree...
4. 4. Regarding the illustrated pump, what is the distance from the bottom of the inlet to the bottom end of the motor shaft?
5. 5. Where would you find a list of the firefighting equipment required on your vessel?

Showing the first 5 of 70. Start at question 1 and use Next to work through the module →