Deck 2014 · 2,572 questions
Deck General - USCG Exam Questions
Seamanship in the broad sense: marlinespike, ground tackle and anchoring, mooring and towing, weather, stability basics, and day-to-day vessel operations.
Every question below is a real U.S. Coast Guard exam question with four choices. Answer one and the correct choice is revealed instantly, with the USCG reference and illustration where the question uses one.
All Deck General questions
Questions 1,101–1,200 of 2,572 · page 12 of 26
- #1101 The most probable position of the object of a search at any given time is the ____________________ .
- #1102 The Muster List ("Station Bill") shows each person's lifeboat station, duties during abandonment, basic instructions, and ___________________ .
- #1103 The muster list must be posted in conspicuous locations and signed by the ____________________ .
- #1104 The name and hailing port of a documented commercial vessel is ___________________ .
- #1105 The National Cargo Bureau represents the ____________________.
- #1106 The next-to-last shot of an anchor cable is usually painted ___________________ .
- #1107 The normal and safest way for a sailor in a bosun's chair to be raised aloft is ____________________ .
- #1108 The normal and safest way for a sailor to be lowered in a bosun's chair when descending vertically is ____________________.
- #1109 The number of able seamen required on board is stated in the ___________________ .
- #1110 The number of certificated able seamen and lifeboatmen required on a vessel is determined by the ____________________.
- #1111 The number of certificated able seamen and lifeboatmen required on board is listed in the ____________________.
- #1112 The number of certificated lifeboatmen required for a vessel is found on the ___________________ .
- #1113 The number or name of a tank barge shall be ____________________.
- #1114 The objective of shoring a damaged bulkhead is to ____________________.
- #1115 The Officers Competency Certificates Convention of 1936 applies to all of these vessels operating seaward of the boundary line EXCEPT a/an ___________...
- #1116 The official identification of a vessel is found in the ____________________.
- #1117 The official logbook is filed with the Officer in Charge, Marine Inspection (OCMI) ____________________ .
- #1118 The official number of a documented vessel is ____________________.
- #1119 The Oil Record Book for all fixed or floating drilling rigs is the property of the ____________________ .
- #1120 The Oil Record Book for all U.S. ships is the property of the ________________ .
- #1121 The oil record book is required to be carried aboard ____________________.
- #1122 The Oil Record Book on a vessel NOT engaged on a foreign voyage shall be maintained on board for not less than ___________________ .
- #1123 The opening in the deck beneath the anchor windlass that leads to the chain locker is the ____________________ .
- #1124 The opening in the deck that leads the anchor cable outside the hull is the ___________________ .
- #1125 The operator of an uninspected vessel MUST assist people affected by an accident if he or she can do so without ____________________ .
- #1126 The operator of an uninspected vessel MUST assist people affected by an accident if he or she can do so without ____________________ .
- #1127 The order of importance in addressing damage control is ___________________ .
- #1128 The organization that certifies the safe working load of cargo cranes on a vessel is the ____________________ .
- #1129 The original Bill of Lading, once signed by the Master, is NOT ___________________ .
- #1130 The owner or Master of a towing vessel must ensure that each person that directs and controls the movement of the vessel knows all of the following EX...
- #1131 The owner or Master of a towing vessel must evaluate whether the entire towline, or a part of it, is no longer serviceable. The towline should be remo...
- #1132 The owner or Master of a towing vessel shall ensure that each person that directs and controls the movement of the vessel can accomplish all of the fo...
- #1133 The owner or Master of a towing vessel shall ensure that each person that directs and controls the movement of the vessel can accurately fix the vesse...
- #1134 The owner or Master of a towing vessel that tows astern must keep records of the towline(s) that include all of the following information EXCEPT _____...
- #1135 The owner or Master of a vessel pushing ahead or towing alongside must ensure that each of the following is appropriate for the vessel's horsepower an...
- #1136 The owner, agent, Master or person-in-charge of a "T- Boat" involved in a marine casualty causing injury that requires professional medical treatment...
- #1137 The owners of the S.S. Short Haul agree to a charter with the Longsplice Steamship Company. The owners stipulate in the charter party that they must a...
- #1138 The part of a windlass which physically engages the chain during hauling or paying out is the ____________________ .
- #1139 The part of an anchor which takes hold on the bottom is the ____________________ .
- #1140 The part of the anchor indicated by the letter F is the ____________________. illustration
- #1141 The part of the anchor indicated by the letter G is the ____________________. illustration
- #1142 The part of the anchor indicated by the letter H is the ____________________. illustration
- #1143 The part of the anchor indicated by the letter I is the ____________________. illustration
- #1144 The part of the anchor indicated by the letter J is the ____________________. illustration
- #1145 The part of the anchor indicated by the letter K is the ____________________. illustration
- #1146 The pea is indicated by which letter? illustration
- #1147 The perforated, elevated bottom of the chain locker, which prevents the chains from touching the main locker bottom and allows seepage water to flow t...
- #1148 The period of roll is the time difference between ____________________.
- #1149 The periodic weight testing of a vessel's cargo booms may be performed by the ____________________ .
- #1150 The phenomenon known as a "seiche" is most likely to occur on Lake Erie ___________________ .
- #1151 The pillar shape that gives the greatest strength for the least weight is the ___________________ .
- #1152 The pipe used to connect two separate piping systems on a tank vessel is known as a ____________________ .
- #1153 The piping that routes an oil cargo from the manifold directly to a cargo tank and serves only one tank is known as a ___________________ .
- #1154 The piping that routes an oil cargo from the manifold to underdeck pipelines is known as a ____________________ .
- #1155 The pitch of a propeller is a measure of the ____________________.
- #1156 The pivot pin at the base of a sheath-screw boom davit must be ___________________ .
- #1157 The pivoting point of a fully loaded vessel with normal trim proceeding ahead at sea speed is ____________________ .
- #1158 The plating indicated by the letter N is known as the ____________________. illustration
- #1159 The Plimsoll mark on a vessel is used to ____________________.
- #1160 The point that is halfway between the forward and after perpendicular and is a reference point for vessel construction is the ___________________ .
- #1161 The primary objective of a Ro-Ro vessel is to ____________________.
- #1162 The primary purpose of a load line is to establish required ___________________ .
- #1163 The primary purpose of the stud is to prevent the anchor chain from ___________________ .
- #1164 The process of lowering a boom to a horizontal position and onto its deck support is called ____________________.
- #1165 The projecting lugs of the rudderpost which furnish support to the rudder are called ____________________ .
- #1166 The proper way to correct a mistake in the logbook is to __________________ .
- #1167 The proximity of pack ice may be indicated by ____________________.
- #1168 The purpose of a bilge well is to ____________________ .
- #1169 The purpose of a devil's claw is to ____________________ .
- #1170 The purpose of item G is to ____________________ . illustration
- #1171 The purpose of sheer in ship construction is to ____________________.
- #1172 The purpose of the stripping bar on an anchor windlass is to ___________________ .
- #1173 The ratio of the height of a vessel's rudder to its width is referred to as the ___________________ .
- #1174 The recessed areas on a wildcat are called ____________________.
- #1175 The regulations require that inspected vessels on an international voyage, other than small passenger vessels, must carry which of the following distr...
- #1176 The responsibility for maintaining the Official Logbook on voyages between the Atlantic and Pacific coasts of the United States rests with the _______...
- #1177 The result of two forces acting in opposite directions and along parallel lines, is an example of what type of stress?
- #1178 The revolving drum of a winch used to haul lines is called a ___________________ .
- #1179 The riding pawl is ___________________ .
- #1180 The rope which is rove from the truck to be used with a bos'n's chair is called a ____________________ .
- #1181 The rope which is the lightest is ____________________ .
- #1182 The rudders are amidships and both screws are going ahead. What will happen if the starboard screw is stopped?
- #1183 The run of plating labeled A is known as the ____________________. illustration
- #1184 The S.S. Hollowpoint has a charter party in which the charterer assumes no responsibility for the operation of the vessel but pays stevedoring expense...
- #1185 The S.S. Microwave has been chartered to the Longline Steamship Company. The Longline Steamship Company agrees to pay all expenses and employ and pay...
- #1186 The S.S. Ossel Hitch arrives in Capetown, South Africa, and the Master affects a note of protest with the U.S. Consul. Why would the Master affect thi...
- #1187 The S.S. Sheet Bend arrives in New York after encountering heavy weather on a voyage from Cape Town. Who will note the maritime protest for the Master...
- #1188 The safe working load (SWL) of wire rope with a safety factor of 6 is what percent of its strength?
- #1189 The safe working load for the assembled cargo gear and the minimum angle to the horizontal for which the gear is designed shall be marked on the _____...
- #1190 The Safety Equipment Certificate shows that the vessel conforms to the standards of the ____________________ .
- #1191 The Safety of Life at Sea Convention was developed by the ____________________ .
- #1192 The safety stopper that prevents the anchor cable from running free if the cable jumps the wildcat is the ____________________.
- #1193 The Scharnow turn should be used in a man overboard situation only when ____________________ .
- #1194 The scuppers had been plugged as required at the time an oil spill occurs on deck. After shutting down the transfer, the engine room should first be i...
- #1195 The section of each end of a barge which is heavily reinforced to take the pressure of pushing is called the ____________________ .
- #1196 The securing of passenger cars on a Ro-Ro vessel requires ___________________ .
- #1197 The securing systems for containers were developed to prevent container movement during which ship motion?
- #1198 The shank is indicated by which letter? illustration
- #1199 The shearing stresses on a ship's structure are usually greatest at ___________________ .
- #1200 The sheave diameter to be used with a 3-inch manila rope is ___________________ .
Other Deck 2014 modules
About the Deck 2014 question pool
This is an older, retired deck question set. It is kept browsable for reference and extra practice, but your exam draws from the current Deck pool, so study that first.