Forums > Engine > Expired / General Subjects: The taper produced by a lathe taper attachment is determined ...
| Question #143 | |
|---|---|
| Link to Question
|
|
| The taper produced by a lathe taper attachment is determined by setting the __________. | |
| A) automatic cross feed | |
| B) tailstock off center | |
| C) guide (swivel) bar | |
| D) compound rest angle | |
| Posted: 23 Apr 2015 08:52 UTC | Post #1 |
|---|---|
| viplovesahni Engine |
Registered Total Posts: 2 |
| offset of bar gives angle | |
1 / 1