Engine : General Subjects - 321/1128
|
|---|
| « Previous Question |
| To properly make and fit a new gasket to a flange, you should __________. |
| A) cut grooves into the flange with a chisel to ensure good gasket contact |
| B) place the gasket over the flange and knock off the excess material with a lead mallet |
| C) make up the flanged joint to make an impression of the flange surfaces to insure a pattern for proper alignment |
| D) remove excess gasket material by trimming with scissors or tin snips |
loading answer...
| Comments |
|---|
| Mario Castillo - 2021-03-03 06:20:52 Expired Member (7) |
| Mallet works better some times. |